PU rapid casting compound SG2000 A+B + hardener, casting compound

Here we offer you a real professional product
High quality, very low-viscosity rapid casting compound
Colour: ivory
Properties: unfilled, very low viscosity, high filling degree possible, good through hardening, very high strength, very heat resistant
Mixing ratio: 1:1
Viscosity: at 25°: 55 + / - 5 mPas
Density at 20°: 1,10 + / - 0,02g / cm3
Pot life 200g / 20°: 7 - 8min.
Demoulding time at RT: 1 - 1,5h

Instructions for use:
The fillers should be stirred into the individual components A and B in such a way that they are approximately
have the same viscosity. Afterwards the two components can be combined very well with each other.
mix.
With small quantities and sufficient routine, it is also possible to first mix the two
unfilled components with each other and then stir in the filler first, without
that the pot life is too short for watering.

General:
The SG 2000 product series is a high-quality, almost odourless two-component polyurethane
Casting compounds without mixed-in filler.
This is only stirred in when the two components are mixed together.

The rapid curing of these materials ensures a short demoulding time. The very low-viscosity binder
enables a high degree of filling. By adding various fillers, the properties and strengths of the material are
for sure.
Containers should be stirred / shaken carefully before use.
The degree of filling and delivery form of the fillers are indicated on a separate mixing table.
The product may be subject to colour variations due to raw materials, these have no influence on the quality and
Properties of the product.

Storage:
In temperate rooms 18 - 25°C
Opened containers must always be sealed and processed as soon as possible.
Please refer to the product labels for the shelf life of the material.

Protective measures:
When processing this product, the protective measures recommended by the Employer's Liability Insurance Association of the Chemical Industry
protective measures must be observed. Follow safety advice.

Disposal:
The cured materials can be disposed of as domestic or industrial waste after consultation with the relevant authorities.
be disposed of.
Uncured products must be disposed of properly after consultation with the competent authority.

Safety advice: